Sunday, September 11, 2016

Full Size Proa

It became more and more obvious that I just as well go ahead and build a full size version rather than continue to fiddle with the models. Sonner or later you got to build your first proa... just to see what you would do different should you build another. This is the 24 ft main hull... complete with dragon heads... and will have about an 18 ft ama. This is based loosely on Gary Dierkings Wa Pa...  though I'm thinking it might make building it easier to make the dragon heads a bolt on addition... just clamps holding this together for the pic. The plan is to have bamboo cross members... set on the stanchions with another set to be in the center. Just a plain butt splice three sheets of plywood with the stanchions located at the splice.A little beamier than his design... about 24 inches widest spot on the bottom... a bit more flare in the sides as well... I hope I don't regret it... just recently noticed that the Wa Pa's built to plans sit pretty deep in the water with two aboard... The ama will be a bit more beefy as well. More interested in more load carrying ability than maximum speed.

Like I said... you need to build one to see what you'd do different.

No comments:

Post a Comment